CNC CABINET WIRE OUTLET GROMMET

CNC CABINET WIRE OUTLET GROMMET

Author name: camaroboy383

Source site: thingiverse

License type: General Public License, others

Category: Other

Reference to source: CNC CABINET WIRE OUTLET GROMMET

Share:

Add to collection

ary

this is an wire outlet grommet for cnc machine cabinets, or 3d printer cabinets,, or for anything you like...you can get a bundle of wires 25mm in dia. through the grommet... its 19mm deep from the flange to the bottom... 30mm o.d and a 35mm flange

the triangle fingers on the bottom will keep a seal from 6mm to 25mm ...

this should be printed in tpu so its flexible

t Settings

Printer:

maker select v2 / CR-10

Rafts:

No

Supports:

Yes

Resolution:

.06 or .1

Infill:

40


Notes:

print in tpu and keep your speeds slow ... use support touching the build plate to support the flange

Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
You may Distribute or Publicly Perform the Work only under the terms of this License. You must include a copy of, or the Uniform Resource Identifier (URI) for, this License with every copy of the Work You Distribute or Publicly Perform. You may not offer or impose any terms on the Work that restrict the terms of this License or the ability of the recipient of the Work to exercise the rights granted to that recipient under the terms of the License. You may not sublicense the Work. You must keep intact all notices that refer to this License and to the disclaimer of warranties with every copy of the Work You Distribute or Publicly Perform.
The name of the Original Author (or pseudonym, if applicable) if supplied, and/or if the Original Author and/or Licensor designate another party or parties (e.g., a sponsor institute, publishing entity, journal) for attribution ("Attribution Parties") in Licensor's copyright notice, terms of service or by other reasonable means, the name of such party or parties; (ii) the title of the Work if supplied; (iii) to the extent reasonably practicable, the URI, if any, that Licensor specifies to be associated with the Work, unless such URI does not refer to the copyright notice or licensing information for the Work; and, (iv) consistent with Section 3(b), in the case of an Adaptation, a credit identifying the use of the Work in the Adaptation (e.g., "French translation of the Work by Original Author," or "Screenplay based on original Work by Original Author").