Magnetic Slug Magnetic Slug Magnetic Slug

Magnetic Slug

Author name: dendad51

Source site: thingiverse

License type: General Public License, others

Category: Other

Reference to source: Magnetic Slug

Share:

Add to collection

ary

This is a fun little critter that 8ran has made. All it lacked was a magnetic personality so it could stick to the fridge.
My TinkerCAD file ....
https://www.tinkercad.com/things/cBD2I7B0AEe-slug

The magnets are 6x2mm.
https://www.ebay.com.au/itm/N35-50-100Pcs-Strong-Block-Ring-Round-Rare-Earth-NdFeB-Neodymium-Fridge-Magnets/142658146914?ssPageName=STRK%3AMEBIDX%3AIT&var=441639981019&_trksid=p2057872.m2749.l2649
A bit if SuperGlue in the hole, press the magnet in and wait for it to dry.
The magnet hole may be a little large but the slug can be scaled to change that if needed.

t Settings

Printer Brand:

Deltaprintr

Printer:

Rafts:

No

Supports:

No

Resolution:

.2mm

Infill:

25%


Notes:

As in the original design comments, you can use 100% infill if you want a better weight.

Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
You may Distribute or Publicly Perform the Work only under the terms of this License. You must include a copy of, or the Uniform Resource Identifier (URI) for, this License with every copy of the Work You Distribute or Publicly Perform. You may not offer or impose any terms on the Work that restrict the terms of this License or the ability of the recipient of the Work to exercise the rights granted to that recipient under the terms of the License. You may not sublicense the Work. You must keep intact all notices that refer to this License and to the disclaimer of warranties with every copy of the Work You Distribute or Publicly Perform.
The name of the Original Author (or pseudonym, if applicable) if supplied, and/or if the Original Author and/or Licensor designate another party or parties (e.g., a sponsor institute, publishing entity, journal) for attribution ("Attribution Parties") in Licensor's copyright notice, terms of service or by other reasonable means, the name of such party or parties; (ii) the title of the Work if supplied; (iii) to the extent reasonably practicable, the URI, if any, that Licensor specifies to be associated with the Work, unless such URI does not refer to the copyright notice or licensing information for the Work; and, (iv) consistent with Section 3(b), in the case of an Adaptation, a credit identifying the use of the Work in the Adaptation (e.g., "French translation of the Work by Original Author," or "Screenplay based on original Work by Original Author").