SpaceX Falcon 9 Rocket (strengthened nozzles) SpaceX Falcon 9 Rocket (strengthened nozzles) SpaceX Falcon 9 Rocket (strengthened nozzles) SpaceX Falcon 9 Rocket (strengthened nozzles) SpaceX Falcon 9 Rocket (strengthened nozzles) SpaceX Falcon 9 Rocket (strengthened nozzles) SpaceX Falcon 9 Rocket (strengthened nozzles)

SpaceX Falcon 9 Rocket (strengthened nozzles)

Author name: icefox1983

Source site: thingiverse

License type: General Public License, others

Category: Other

Reference to source: SpaceX Falcon 9 Rocket (strengthened nozzles)

Share:

Add to collection

ary

Great model and all credits go to the original modelers. My primary change was strengthened nozzles; see before-after comparison. The original nozzles were very fragile and almost unprintable at larger scales. (Ironically smaller scales print ok because the thin nozzles necks are not sliced.) In addition I separated the 1st stage into two pieces so the rocket can be printed at 200% on my Prusa i3 MK2S. The dragon capsule is highly detailed and requires a 200% scale and 0.1mm layers to really show details.

Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
You may Distribute or Publicly Perform the Work only under the terms of this License. You must include a copy of, or the Uniform Resource Identifier (URI) for, this License with every copy of the Work You Distribute or Publicly Perform. You may not offer or impose any terms on the Work that restrict the terms of this License or the ability of the recipient of the Work to exercise the rights granted to that recipient under the terms of the License. You may not sublicense the Work. You must keep intact all notices that refer to this License and to the disclaimer of warranties with every copy of the Work You Distribute or Publicly Perform.
The name of the Original Author (or pseudonym, if applicable) if supplied, and/or if the Original Author and/or Licensor designate another party or parties (e.g., a sponsor institute, publishing entity, journal) for attribution ("Attribution Parties") in Licensor's copyright notice, terms of service or by other reasonable means, the name of such party or parties; (ii) the title of the Work if supplied; (iii) to the extent reasonably practicable, the URI, if any, that Licensor specifies to be associated with the Work, unless such URI does not refer to the copyright notice or licensing information for the Work; and, (iv) consistent with Section 3(b), in the case of an Adaptation, a credit identifying the use of the Work in the Adaptation (e.g., "French translation of the Work by Original Author," or "Screenplay based on original Work by Original Author").