WEATHER VANE WIND SPEED WEATHER VANE WIND SPEED WEATHER VANE WIND SPEED WEATHER VANE WIND SPEED WEATHER VANE WIND SPEED WEATHER VANE WIND SPEED WEATHER VANE WIND SPEED WEATHER VANE WIND SPEED

WEATHER VANE WIND SPEED

Author name: jynx1966

Source site: thingiverse

License type: General Public License, others

Category: Other

Reference to source: WEATHER VANE WIND SPEED

Share:

Add to collection

ary

weather vane that you can connect a wind meter to, inspired by one I made of wood along time ago
I did notice that (ALEXGATORFAN) had a similar design.to what I had made , so I did use some of his parts and modified them to save time.

t Settings

Printer:

Anycubic i3 mega


Notes:

I recommend reading this and doing a dry run to make sure you understand my lame instructions,
take the (tri Mount) put a 1/4 20 nut into slot then put a bolt in bottom to hold nut in place, couple drops of your favorite glue to secure the nut, then remove the bolt.

now add some glue to the grooves on all 3 sides of the Tri mount and insert it into the TRI mount part B.

Next take a 30x10mm bearing, make sure it spins easily before assembly. insert it into the bearing box .place the small round disc on top of bearing to sandwich it all together. once again couple drops of glue to the disc to keep it all together.

now gently tap the bearing assembly onto the TRI mount center post.
now the whole assembly will mount on a tripod. and the bearing should spin freely.
glue the Holder on top of the bearing box( keep in mind there is a hole in the Holder to secure your meter. so make sure you don't cover it up when gluing the twp parts together.
Finally glue the tail connector to the front of the tail, there is a slot in it for the tail, just can't see it in the picture unless using 3d view.
the hole in the holder and in the tail holder is a 1/4", so you can get a piece of 1/4 wood, cut it to desired length and sand it to fit and you are done

Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
You may Distribute or Publicly Perform the Work only under the terms of this License. You must include a copy of, or the Uniform Resource Identifier (URI) for, this License with every copy of the Work You Distribute or Publicly Perform. You may not offer or impose any terms on the Work that restrict the terms of this License or the ability of the recipient of the Work to exercise the rights granted to that recipient under the terms of the License. You may not sublicense the Work. You must keep intact all notices that refer to this License and to the disclaimer of warranties with every copy of the Work You Distribute or Publicly Perform.
The name of the Original Author (or pseudonym, if applicable) if supplied, and/or if the Original Author and/or Licensor designate another party or parties (e.g., a sponsor institute, publishing entity, journal) for attribution ("Attribution Parties") in Licensor's copyright notice, terms of service or by other reasonable means, the name of such party or parties; (ii) the title of the Work if supplied; (iii) to the extent reasonably practicable, the URI, if any, that Licensor specifies to be associated with the Work, unless such URI does not refer to the copyright notice or licensing information for the Work; and, (iv) consistent with Section 3(b), in the case of an Adaptation, a credit identifying the use of the Work in the Adaptation (e.g., "French translation of the Work by Original Author," or "Screenplay based on original Work by Original Author").