Wolfwire hinge Wolfwire hinge Wolfwire hinge

Wolfwire hinge

Author name: Sparkcrusher

Source site: thingiverse

License type: General Public License, others

Category: Other

Reference to source: Wolfwire hinge


Add to collection


Replacement hinge for Titant Return Wolfwire. will need some work to make fit, just remove the pin, cut off the similarly shaped bit of soft red plastic off the canopy and shave down the details on the underside of the hinge near the hinge so the printed part sits flush, then glue it in place. only do this if you know what you are doing, and im not responsible for you damaging your figure.

t Settings


Sintron Prusa i3








print at 0.1mm layer height, and print about 50mm/s. printed mine in PLA due to the small tolerances on the part

Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
You may Distribute or Publicly Perform the Work only under the terms of this License. You must include a copy of, or the Uniform Resource Identifier (URI) for, this License with every copy of the Work You Distribute or Publicly Perform. You may not offer or impose any terms on the Work that restrict the terms of this License or the ability of the recipient of the Work to exercise the rights granted to that recipient under the terms of the License. You may not sublicense the Work. You must keep intact all notices that refer to this License and to the disclaimer of warranties with every copy of the Work You Distribute or Publicly Perform.
The name of the Original Author (or pseudonym, if applicable) if supplied, and/or if the Original Author and/or Licensor designate another party or parties (e.g., a sponsor institute, publishing entity, journal) for attribution ("Attribution Parties") in Licensor's copyright notice, terms of service or by other reasonable means, the name of such party or parties; (ii) the title of the Work if supplied; (iii) to the extent reasonably practicable, the URI, if any, that Licensor specifies to be associated with the Work, unless such URI does not refer to the copyright notice or licensing information for the Work; and, (iv) consistent with Section 3(b), in the case of an Adaptation, a credit identifying the use of the Work in the Adaptation (e.g., "French translation of the Work by Original Author," or "Screenplay based on original Work by Original Author").